IC-7300 FIRMWARE


HOME DOCUMENTATION SOFTWARE FIRMWARE HOWTOs TECHNOTES USEFUL TOOLS OTHER SOFTWARE OTHER HARDWARE VIDEOS MISCELLANEOUS FEEDBACK MORE G3NRW SITES

Note: This table includes various IC-7300 firmware versions that are currently available from Icom. The first entry in the table is the latest version, and is the version you would normally install in the rig

Firmware VersionRelease DateNotes
v 1.145 October 2016LATEST UPDATE
Improvements
A particular spurious signal in the Fixed mode Spectrum scope screen is eliminated.
Flickering of the Spectrum scope screen is reduced.
Accuracy of the spectrum scope in the CW mode is improved.
Frequency response near the edges of the spectrum scope is improved.

Problems solved
"CI-V USB→REMOTE Transceive Address" setting problem was fixed.
Unnecessary OVF indication at the end of the transmission was fixed.
Other minor problems were fixed.

The firmware will be updated to the following versions.
Main CPU: 1.14
DSP Program: 1.07
DSP Data: 1.00
FPGA: 1.13
v 1.1327 May 2016Improvements

FM TX audio S/N ratio

The firmware will be updated to the following versions.
Main CPU: 1.13
DSP Program: 1.07
DSP Data: 1.00
FPGA: 1.12
v 1.1214 April 2016 Improvements
Audio processing improvement in SSB mode transmission
Minor graphic update

The firmware will be updated to the following versions.
Main CPU: 1.12
DSP Program: 1.06
DSP Data: 1.00
FPGA: 1.11


To update the firmware

  1. An SD card or an SDHC card is required.
  2. Format the card in the IC-7300 before using it for the update. (First, save any data that is on the card, if necessary.)
  3. Unzip and save the downloaded firmware file in “IC-7300” folder that is on the card.
  4. Save the transceiver’s data onto a separate card before doing the update. It is possible that your data could get lost or corrupted during the update. Thoroughly read Section 8 (USING AN SD CARD) of the “FULL MANUAL” for details.
  5. Thoroughly read Section 15 (UPDATING THE FIRMWARE) of the “FULL MANUAL” before starting the update.
  6. Never turn OFF the transceiver power during the update.

 


HOME DOCUMENTATION SOFTWARE FIRMWARE HOWTOs TECHNOTES USEFUL TOOLS OTHER SOFTWARE OTHER HARDWARE VIDEOS MISCELLANEOUS FEEDBACK MORE G3NRW SITES